FLY WHEEL PULLER 62mm x 1mm

FLY WHEEL PULLER 62mm x 1mm RH. DUCATI

It fits Ducati 250/350/450 and most later bevel single wide-case models.

HOLDER O.D.: 68MM, Thread I.D.: 62mm, LENGTH: 79MM.

BOLT: 1/2" X 12UNC, LENGTH: 93MM, SIDE TO SIDE: 19MM.

• Hard black oxide finish.


• The only way to remove that flywheel unless you're a hammer-toting, knuckle-dragging mouth-breather


• This professional puller should be in the toolbox of every owner of Ducati singles.


• The new design has a replaceable brass bushing at the contact point, and it should fit all later wide-case machines.


• It will NOT fit pre-'68 narrow-case models.

NOTE.

Please check the thread size of your motor before ordering

Tips on use.

- Make sure the flywheel thread is clean of dirt and not damaged before screwing the puller in.

- Use copper grease on the puller threads, for long life.

- Make sure the puller is fully screwed into the flywheel.

- After tightening use a hammer on the centre and tap to jolt free [not always need].

- If using old flywheel pullers make sure the threads are in good condition before use to avoid damage to flywheel.

[FACTORY IMAGE RACING] (Distributed oro2u.com)

Cross Reference Numbers Only:

UP-12231, 88713-0411